Samsung AC024JXADCH Installation Manual - Connecting The Cable
15
ENGLISH
Connecting the cable
Two electronic cables must be connected to the outdoor unit.
f The connection cord between indoor unit and outdoor unit.
f The power cable between outdoor unit and auxiliary circuit breaker.
f Be sure to run the power supply cable and the communication cable through
electrical conduit as seen in the picture.
f Separately protect the power and communication cable using approved conduit.
- Conduit is not supplied with the product.
f Make a knockout hole.
f After making a knockout hole, apply rust resisting paint around the hole.
f Secure the cable tube to the outdoor knockout using the CD connector and
bushing.
• During unit installation make refrigerant connections first then
electrical connections. If removing the unit disconnect electrical
cables first, then refrigerant connections.
• Connect the air conditioner to grounding system before
performing the electrical connection.
• When installing the unit, you shouldn't use inter connection
wire.
CAUTION
Conduit
Example of Air Conditioner System
When using ELCB for 1 phase
Indoor Unit
Power cable
Outdoor Unit
Communication cable
Grounding
OR
Power cable
Communication cable
❋ If an outdoor unit is installed in a place in danger of an electric leak or submergence, you must install the ELCB.
• AC030JXSCCH, AC036JXSCCH
- ELCB must be installed since this product is equipped with a base heater.
CAUTION