Samsung AJ040MCJ2EH Installation Manual - page 23
23
English
Instal
lation Pr
oc
edur
e
Installing an additional indoor unit after installation
1
After installing the indoor unit while the outdoor unit
is turned off, turn on the outdoor unit, and check if
the LED indications change as shown in the following
table:
A
B
RED
GRN
RED
GRN
YEL
2
Press the K1 button once. The LED indications change
as shown in the following table.
A
B
RED
GRN
RED
GRN
YEL
3
After a while, the LED indications change as shown in
the following table.
A
B
RED
GRN
RED
GRN
YEL
4
Press the K1 button to start a reinstallation. (Refer to 3
and 4 in Setting the indoor unit address and inspecting
the pipes automatically.
A
B
RED
GRN
RED
GRN
YEL
Setting the indoor unit addresses manually
1
Turn off the switch 1 of the DIP switch, and then turn
on the outdoor unit.
2
Manually set the indoor unit options by referring to
page 24~29.
3
Press the K3 button once or reset the outdoor unit.
NOTE
•
Key information
K1
Pipe Checking Operation
K3
Reset