ServComp 10 User Manual - page 25
IP Phone User manual
- 24 -
n
stun: Select this item with eproxy private system used. This item only be used in SIP
protocol.
● nat addr: When “nat traversal” is set to “enable”, please put the domain name of the servers
( These web server helps to find out the public IP of the IP Phone) into
“nat addr ”, such as
www.whatismyip.com.
● nat ttl: When IP Phone sit behind a NAT device, it will send packets to server every
“nat ttl ”
seconds to keep the port mapping on the NAT device alive.
“nat ttl” is an integer between 10
and 65535 .default value is 20.
● phone number: The local phone number or username of this phone, usually is allocated by
Sever provider. The Max length is 16 digit
.
● account: when you use calling card(such as etalk,Net2phone) or some special severice, please
input the account of chosen card into this field,however ,as for MGCP ,no this item. And when
you use H.323 protocol to log on the Gatekeeper,please input H323ID in this column if the
account item is selected in local model dropdown list;however if H235 item is selected in local
model dropdown list, please enter user name here; While prefix item selected in use dialplan
dropdown list, enter language indicating number, card number and # here, such as 14589653185
#. When use SIP or IAX2 protocl ,please enter account to this column.
● pin: While calling card is set, please model the password of chosen card into this field; while
md5 account item selected in local model dropdown list, enter password here. While
prefix
item selected in use dialplan dropdown list, enter password and # here, such as 3185
#. For
MGCP protocol ,no this item.
● endpoint id
:this item can only be used in MGCP,please input Local name of EndpintID to this
column.
● domain name
:this item can only be used in MGCP,please input Domain name of EndpintID to
this column.
● ras port: Set the register port ; can be any number between 1024 and 65535 . This item only
be used in H.323 protocol.
● q931 port: Set the call signal port; can be any number between 1024 and 65535. This item only
be used in H.323 protocol.
● h245 port: Set thecontrol port , can be any number between 1024 and 65535. This item only be
used in H.323 protocol.
● rtp port: RTP port is the port transferring and receiving voice packets using UDP protocol. This