SEVERIN HAND BLENDER Instructions For Use Manual - page 8
head will cause the appliance to switch off
automatically in order to prevent personal
injury or damage to the appliance.
Batteries
Th
is appliance requires two batteries of
type LR14 / 1.5 V (size C); the use of
alkaline batteries is preferable, as they are
longer-lasting than the standard carbon-
zinc batteries. Th
e batteries are inserted as
follows:
Slide the battery compartment cover in
–
the direction indicated by the arrow and
take it off .
Insert the batteries according to
–
the schematic diagram inside the
compartment, ensuring correct polarity
(+/-).
Replace the compartment cover and slide
–
it back until it is heard locking into place.
When the lint chamber is empty, a
z
signifi cant decrease in operating speed
is a clear indication that the batteries
are exhausted, and that they should be
replaced.
Never dispose of old batteries in your
z
domestic garbage. Old batteries must be
disposed of through local ‘special garbage
collection points’.
Operation
Place the item to be treated on a level
–
surface.
Remove the protective cover from the
–
head. For coarser wool surfaces, the use of
the spacer ring is recommended.
Use the On-/Off switch to turn the
–
appliance on. Th
e shaving blades inside
the shaving head start rotating. When
they come into contact with the surface of
the area to be treated, a distinct noise can
be heard. Th
is is normal.
Guide the shaving head gently and without
–
exerting any pressure over the fabric to be
treated. Lint and fuzz balls are removed
and collected in the lint chamber.
Th
e chamber should always be emptied
z
in good time. If the motor seems to lose
power, or if it stops working completely,
the lint chamber may be over-full.
Turn the appliance off aft er use.
–
General care and cleaning
Before cleaning the appliance, turn the
z
motor off and remove the batteries from
the battery compartment.
To avoid the risk of electric shock, do not
z
clean the appliance with water and do not
immerse it in water.
Do not use abrasives or harsh cleaning
z
solutions.
To empty the lint chamber, slide it out of
–
the appliance in the direction indicated
by the arrow. Once emptied, slide the
chamber back into the appliance until it is
heard locking into place.
Th
e exterior housing may be wiped with a
–
slightly damp soft cloth.
Th
e shaving head can be cleaned as
–
follows:
Remove the spacer ring and the protective
–
cover from the appliance.
Take off the shaving head by unscrewing it
–
in an anti-clockwise direction.
Caution
–
: Exercise extreme caution when
removing the lint residues. Th
e blades are
very sharp, and there is a risk of injury.
Replace the head back on the appliance
–
and turn it clockwise to secure. Replace
the protective cover and – if applicable –
the spacer ring.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
Th
is product is guaranteed against defects
8