Smart-e SDS-901 User Manual - Installation And Operation
5. System Power up
5.1
Turn the system on by plugging in the power adapter to the
SDS-900 Transmitter (or Receiver if preferred)
5.2
Power up your computer.
5.3
Observe both transmitter and receiver power LED are ON,
and source device is switched on.
6. Preparing and connecting System CAT-5 cable
The SmartLynx utilizes category 5 (CAT 5), unshielded twisted pair (UTP) cable to
transport signal between transmitter and receiver.
CAT 5 cable is more desirable than coaxial cable, due to its low cost and ease of
installation. This cable is used for LAN applications and is found in abundance,
already installed, in many buildings . The category 5 is a standard which estab-
lishes minimum requirements for telecommunications cabling within a commer-
cial building. The standard covers various aspects of wiring including telecommu-
nications outlets.
Following is the wiring standard for terminating CAT 5 cable using RJ 45 connec-
tor:
Pair 1
Pins 1 & 2
Pair 2
Pins 3 & 6
Pair 3
Pins 4 & 5
Pair 4
Pins 7 & 8
Connectors:
RJ-45
Capacitance:
14 pf/ft (46.2 pf/m)
Conductor Gauge:
24 AWG
Impedance:
100 +/- 15 ohms
4 - Pair
Installation and Operation
-
7-