Smart-e SDS-901 User Manual - Installation And Operation
of
16
Installation and Operation
2. Connect Transmitter to the video signal source
2.1
Connect the HDMI output of the source device to the input of the
transmitter using a high quality HDMI cable
2.2
If needed connect the audio input to either an analogue or a TOSlink
output of the AV source. Select audio type as required by pressing
the Audio Select button on the front panel and check the audio
status LED — on for analogue, off for digital
2.3
Connect the Cat cable to the RJ45
2.4
Plug in the 24V PSU and connect to the mains, check the power
LEDs — green on RJ45, shows 24V inline power, green on front
panel, shows internal 5Volts
-
4-