User manual aec-931a2bs motion sensor twin light with warning message.
1 table of contents 1. Contents of package ...................................................................Page 1 2. Smartguard™ motion light with video camera .......................Page 3 3. Assembly ....................................................................................Page 3 4. I...
2 ① ② ③ user manual aec-931a2bsd motion sensor twin light with video camera smartguard tm jcd g8 bulb user manual ④ ⑤ ⑥ screw d ⑦ screws plastic masonry plugs wall mount (cross bar) wire nuts.
3 smartguard™ motion light with video camera overview step 1. Assembly 1. Install/replace the halogen bulb (see fig. 3) make sure to unplug unit or turn off power first. Remove floodlight cover by twisting cover anticlockwise. If replacing a bulb, take out the existing halogen light bulb (part no. ②...
4 step 2. Installing the smartguard™ motion light with video camera important if in any doubt about the installation of this product, consult a qualified electrician - this product must be grounded - do not mount the unit against inflammable surfaces - the motion detector will not operate correctly ...
5 installation to a junction box using crossbar mount (see fig. 5 & fig. 6): 1. Attach the crossbar (part no. ⑥ ) to junction box and fix by screw c. 2. Feed the cable through the back mounting plate. 3. Fix the mounting plate to crossbar (part no. ⑥ ) by screw d 4. Connect the black wire (live wire...
6 installing your smartguard™ motion light with video camera on surface without a junction box. (see fig. 6 & fig. 7) 1. Place plastic masonry plugs (part no. ⑤ ) into desired surface aligning holes as shown below. Using an electric screwdriver, fasten mounting plate directly to surface using screws...
7 screw a please allow 1 minute warm-up time after switching on. Step 3. Adjusting the settings (see fig. 8~9) time control：turn the time control knob to”+” side to increase the illumination time (7 minutes max.), turn the control knob to “－“ side to reduce the illumination time (30 seconds min.). S...
8 mode 3: perfect for a place of business - light at night + speaker at night - daytime: light is off, speaker is off - nighttime: light is on, speaker is on audio mode: for selecting which audio message will play when motion sensor detects movement. - pre-set default is “you are trespassing” - push...
9 general information and safety special care instructions!!! The smartguard motion sensor twin light is designed to be weather resistant. Never attempt to immerse the unit in water or any other liquid. This will damage the unit and void the warranty. This product is designed to illuminate and make ...
10 fcc information this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warni...
