Smartguard AEC-931A2BS User Manual - Light With Video Camera
4
Step 2. Installing the Smartguard™ Motion
Light with Video Camera
IMPORTANT
IF IN ANY DOUBT ABOUT THE INSTALLATION OF THIS PRODUCT, CONSULT A
QUALIFIED ELECTRICIAN
- This product must be grounded
- Do not mount the unit against inflammable surfaces
- The motion detector will not operate correctly if it is installed:
1 Near the outlet of a central heating boiler
2 Near air conditioning plant
3 Pointing directly at moving vehicles
4 Within sight of reflections from moving water
5 Where other lamps could shine on the detector
BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT
THE ELECTRICAL SUPPLY IS SWITCHED OFF AND THE CIRCUIT FUSES
REMOVED OR THE CIRCUIT BREAKER IS IN THE OFF POSITION.
Please make sure the voltage and polarity are correct before connection.
Incorrect voltage may cause electric shock. If you are not sure, please
contact your retailer.
Note: It is recommend to mount Smartguard™ Motion Light with
Video Camera 6 – 7ft above the ground for optimum performance,
do not mount the fixture below 3.94ft. See below figure for details of
performance range.
Detection range: 32.8ft x 180
° (see fig. 4)
Fig. 4