SmartPay D210E User Manual - Getting Started
4
•
Switch the D210e power on/off by pressing & holding the cancel/power button (X CANCEL)
for 3 seconds. Check that is has full battery power by looking at the battery icon in the top
right corner of the display screen.
•
If you need to charge your terminal, use the power cables supplied to plug into the side of
the unit and into an appropriate mains power supply. If you have ordered a Base Station,
place the terminal on it to charge. The Base Station must be connected to an appropriate
power supply using the power cable supplied. The D210e terminal battery requires regular
mains charging, much like a mobile phone. The battery charge can last up to 8 hours
depending on frequency of use.
•
Lift printer cover flap to check the paper roll does not need to be replaced and is seated
correctly in the printer well.
•
If you need to load a new paper roll ensure tongue of paper is feeding up from underneath
the roll and close the lid firmly leaving tongue of paper sticking out above the cutting blade.
i
iii
ii
iv
•
Thermal Printer (lift flap to change paper roll)
•
Paper Cutter
•
Contactless NFC Reader
•
Printer Cover Lift Grip
•
LCD Display Screen
•
Card Swipe Reader
•
Power Charging Port
•
Menu Key
•
Cancel Key
(Power On/Off)
•
Clear Key
•
Enter Key
•
Card Chip Reader
1
3
8
5
10
2
7
4
9
6
11
12
Getting Started
1
2
5
7
11
3
8
4
6
9
10
12
Battery located underneath