SmartPay D210E User Manual - Connecting Using Wi-Fi
6
Power On - Press and hold power button for 3 seconds until LCD screen backlight comes on.
If terminal is turned on successfully, the PAX logo will appear on screen and you will hear a beep.
Allow the terminal to automatically run through its initialisation cycle before the
EFTPOS "ready" screen appears. At this point the terminal is ready for use.
1
2
Connecting using 3G (Sim Card)
•
Power On - Press and hold power button for 3 seconds until LCD screen backlight comes on.
If terminal is turned on successfully, the PAX logo will appear on screen and you will
hear a beep.
Allow the terminal to automatically run through its initialisation cycle.If the terminal
had previously been setup to access your WiFi, it will reconnect automatically.
1
2
Connecting using Wi-Fi
Internet Connection
In order to process payments, your D210e EFTPOS terminal has to be connected to the internet.
The D210e will be setup to use either cellular, Wi-Fi or the separate B210 base.
If the D210e is setup for cellular then the will display the current signal strength.
If the D210e is setup to use the intelligent base then the will light up.
If the D210e is to use Wi-Fi then it will need to be setup to use your wireless modem/router, mobile
phone (Wi-Fi personal hotspot) or a mobile Wi-Fi hotspot device. Wi-Fi signal strength is shown by the
To setup Wi-Fi you will need to make sure your internet connection is activated, you have data, and (if using) your
modem/router that it does not have any special configuration settings, network traffic restrictions or filters.
Please be aware that if your network signal is not strong enough you may experience issues
using the D210e. Also, Smartpay does not recommend using public or unsecured Wi-Fi networks
to process payments.