SmartWitness KP1S Installation Manual

Manual is about: 3G/WiFi Enabled Telematics Camera for Commercial Vehicles

Summary of KP1S

  • Page 1

    Www.Smartwitness.Com smartwitness kp1s + svc400 installation guide v.1.2 warning: smartwitness installations should be performed by a qualified individual or installation professional only. Working with a vehicle's power system can be dangerous to both you and your vehicle. This installation is inte...

  • Page 2

    Www.Smartwitness.Com kp1s contents & diagram: *depending on the order, the 3g modem and/or sd card may or may not be included. **sd cards, secondary camera, power adaptor, and 3g modems may be in a separate package from the kp1s (common in large, bulk orders). Kp1s recorder with locking cover power ...

  • Page 3

    Www.Smartwitness.Com kp1- svc400-av video output cable svc400-s contents & diagram svc400 12v recorder/cam hub sd-32 sd card (pc viewer software is on the provided sd card.) svc400-pc power cable svc400-lc locking enclosure/mount (optional) rca-cnvrt rca to 2.5mm stereo adaptor (3ea) video output to...

  • Page 4

    Www.Smartwitness.Com kp1s connected with svc400 “kp1- svc400-av”.

  • Page 5

    Www.Smartwitness.Com connecting camera 4: (rca input) to svc400 1. Rear backup camera (any smartwitness camera ending in “-c”, ( i.E. Sva036-c ) 2. Extension cable for rear backup camera. 3. Rca adaptor cable. 4. 12v power and ground for rear backup camera connect to ign (+) and gnd (bat-). 5. Rca i...

  • Page 6

    Www.Smartwitness.Com connecting 12v camera (cameras ending in “-c” such as sva025-c) & lcd monitor stereo) for customers requiring the svc400 connected cameras to also display on lcd monitorconnect the male usb port from the 3g modem into the female usb port as seen in picture below. Secure the male...

  • Page 7

    Www.Smartwitness.Com link to download svcspwk-bw2 datasheet (pdf.

  • Page 8

    Www.Smartwitness.Com connecting 3g cellular modem (optional) connect the male usb port from the 3g modem into the female usb port as seen in picture below. Secure the male/female usb connection with the provided silicone cold shrink tape. The tape is self- fusing and does not require heat to be appl...

  • Page 9

    Www.Smartwitness.Com remove the 3m adhesive backing and secure the modem to the windshield. The excess usb cable and kp1s cable should be tucked neatly in the roof lining or along the edge of the windshield. It is recommended to adhere the modem above the as1 line, in the “blue zone” of the windshie...

  • Page 10

    Www.Smartwitness.Com troubleshooting • the kp1s has a solid red light on as well as solid green and blue o solid red led indicates the 2 nd camera channel is not receiving video signal. Please check the camera connection. • the kp1s blue light is solid but the green light is blinking or off o check ...