SmartWitness KP1S Installation Manual - page 6
www.smartwitness.com
Connecting 12V camera (cameras ending in “-C” such as SVA025-C) & LCD
Monitor stereo)
For customers requiring the SVC400 connected cameras to also display on LCD monitorConnect the
male USB port from the 3G Modem into the female USB port as seen in picture below. Secure the
male/female USB connection with the provided silicone cold shrink tape. The tape is self-fusing and
does not require heat to be applied. It stretches 300% and is fully fused within 24 hours after
application. It is best to stretch
*If “-C” camera extension cables have only 1 RCA male
Then use the provided Y connector instead
If customer desires display control based
on vehicle triggers, then connect the
corresponding LCD trigger wire to the
vehicle input sensor. I.e. if Rear Backup
camera is connected to LCD input #4, then
connect the grey # 4 trigger wire to rear
backup sensor. The camera will display full
screen when the trigger wire receives 12V.
Link to download SmartWitness 7” LCD
monitor data sheet (PDF)
(to LCD Monitor)
(to Camera)
(to 12V Power and ground)
(to SVC400 ch 1, 2, 3, and/or 4)
“RCA-Y-SPLT”