SMC Networks SBC-2400 series User Manual - General Matters
Thank you very much for purchasing our brush cutter !
Our top priority is customer safety. Before use, please be sure to read this manual
which explains safety procedures, assembly of the machine and instructions for use, etc.
Please use the machine safely and efficiently at all times. If you have any questions, please
contact the store where you purchased our product.
*
BE SURE TO OBSERVE THE FOLLOWING
FOR SAFE USE THE BRUSH CUTTER !
*
BRUSH CUTTER / TRIMMER
IMPORTANT SAFETY INFORMATION
1.
GENERAL MATTERS
(1) The brush cutter is designed to cut weeds.
Never use it for any other purpose, such as cutting tree branches, etc.
(2) Wear clothes with tight fitting long sleeves and trousers
No loose sleeves or trouser bottoms) , a protective cap (safety helmet), gloves,
dust- proof glasses and safety shoes.
(3) Prepare a whistle, an axe, and a hatchet.
(4) Be sure to put the blade guard in the specified position.
(5) Do not use the machine when tired!
Under the influence of alcohol or after taking medication.
(6) Children, pregnant women or untrained personnel must not use the machine.
(7) Do not lend the brush cutter to people who are not properly trained
Or well - experienced with its operation.
(8) Do not use the machine during the night or in bad weather conditions.
2.
BRFORE OPERATION
(1) MACHINE INSPECTIONS:
1-1. Use the machine only after making sure that there are no abnormalities.
Check items: ・Missing or loose screws.
・Lubricant Oil, grease and fuel are in their proper locations.
・There are no fuel leaks.
1-2. Check the engine type, 2-cycle engine is used the mix ratio of fuel is
50 (gasoline) to 1 (oil). Mix fuel carefully, because an improper mixing ratio will result
in burning or excessive wear of the engine.
1-3. Check the engine type, 4-cycle engine is no need to mix gasoline & oil.
1-4. Make sure that the engine is cooled down before refueling.
Refuel the machine in a safe area.
1-5. Fuel is flammable. Never smoke when refueling. Never refuel near fire.
Be sure to keep the machine away from fire. If fuel spills whilst refueling,
thoroughly wipe it up before continuing.
1-6. Use the machine after making sure that there are no abnormalities
of the cutter mechanism: e. g ., The blade is mounted securely,
the teeth of the blade are properly set and the cutter is not damaged in any way.
1-7. Be sure to put the blade guard and the shoulder band on the machine.
(2) WORKING SITE INSPECTIONS:
1-1. Use the machine after making sure there are no cans,
wires or pebbles in the work area.
1-2. Specify an area within a 15m radius from the operator as a dangerous area.
Warn people by surrounding the area with a rope and putting up a notice.
Prevent people and pets from entering the area. If a person or a pet approaches
within a 15m distance, immediately stop the engine. If two people or more work
together with the machines, work 15m apart from each other.