SPT WA-1061H Instructions Manual - page 5
5
INSTALLATION
The unit is a portable air conditioner that may be moved from room to room.
1. Installing the plastic slider kit.
FIG.8
Extend both ends of the exhaust hose by few inches.
Connect hose to the back of unit by turning clockwise – do not over tighten.
Connect adapter piece to hose by turning clockwise (with opening end facing you).
Determine how many sections of the slider kit your window requires.
Place slider kit inside the window frame and adjust height accordingly. Once set, insert
the small screw through side opening to secure.
Align and insert adapter piece to opening on window kit.
Slide window close against the window kit.
The best distance between the machine and window or wall is 31-39 inches.
Mounting of the exhaust pipe
•
Use only the hose provided and clip exhaust hose
to the back of the air conditioner
•
Avoid kinks and bends in the exhaust hose. If
expelled air is not exhausted smoothly, it will build
up in the hose and lead to unit overheating and
shutting down. Refer to Fig 11 & 12 for correct
position.
•
The hose may be extended from 11” to 59”. But
for maximum efficiency, use the shortest length
possible.
WARNING!
The length of the exhaust pipe is specially designed
according to the specification of this product. Do not
replace or prolong it with your own private hose as this
could cause the unit to malfunction.
Window kit