SRS Labs DVD-1 Instructions For Use Manual - Installation
INSTALLATION
DVD-1
Instructions for Use. Page 9 of 22
If you move your DVD player from a cold
place to a warm place, leave it switched off
for a few hours before using it again.
Condensation could form inside the unit
and must be allowed to evaporate.
CLEANING
Before cleaning the DVD player always
switch off the main switch and remove the
mains plug from the wall outlet. Clean the
housing and the remote control unit using a
moist cloth. We do not advise that you use
any solvents, white spirits, thinners, etc. as
they could damage the surface finish of the
unit.
NOTES ON USING CD and DVD DISCS
Always hold discs by the edges and make
sure they remain clean. Do not touch the
surface. Do not stick any paper or adhe-
sive tape to either side of the disc. Keep
discs away from direct sunlight and heat
sources, such as radiators. Do not leave
discs in a car parked in direct sunlight,
since the temperature inside the car can
become extremely high. Clean discs with
a cloth before playing them. Do not use
any solvents such as benzene, thinners,
commercially available cleaners or antistat-
ic spray intended for analogue discs, to
clean your discs. After playing, always
store a disc in its case again.
INSTALLATION
Place your DVD player on a stable, hori-
zontal, vibration-free surface where there
is no risk of it falling over or being sub-
jected to vibrations. Avoid placing your
DVD player next to radiators or in direct
sunlight.
Protect your DVD player from humidity.
Avoid placing it under a window. Do not
place any containers filled with water on
the DVD player e.g. flower vases or potted
plants. If water does enter the DVD play-
er, immediately pull out the mains plug
from the wall socket and inform your deal-
er, who should then check the set before
you use it again.
- Liquid entering the DVD player could
cause dangerous short-circuits which, in
the worst case, could cause a fire.