SSV Embedded Systems IGW/400-CAN User Manual - page 10
Manual is about: WLAN Device Server
of
11
IGW/400-CAN – Upgrading the IGW/400-CAN Firmware
S S V E M B E D D E D S Y S T E M S
10
3.5
Complete the Firmware Upgrade
After the successfully completed firmware upgrade you will see this window:
Figure 7: Firmware upgrade successfully completed
Please follow now these steps:
1. Exit the Philips LPC2000 Flash Utility.
2. Disconnect the power supply cable from the plug-in power supply.
3. Remove the jumpers on the IGW/400-CAN.
4. Close the case of the IGW/400-CAN.
That’s it! Now you can start the IGW/400-CAN again and work with the new firmware.