Surveon Linux Series Quick Installation Manual - page 2
/4
2/3
When you run the SMR series for the first time, you need to go through the following steps
within the Install Wizard after logging in.
1. Choose your language from the drop-down list.
Run the Install Wizard
6
Click “Next” to go to the next step Confirm the number of your hard drives.
3. Recording plan: Select the best storage configuration for the system.
Note:
Date/Time should be set correctly before recording.
4. Time: Time setup should be done correctly, otherwise some of the functions will be affected.
Set up the time zone before setting up the time.
2.Confirm the number of your hard drives: the system will auto detect the number of installed hard drives.
Check if the detection result is correct, if yes, click ”Yes and proceed” or “Next” to go to the next step
Recording plan.
If the detection result is not as expected, click ” No and shutdown”. Shutdown the system and make sure
all the drives are installed properly. After checking, restart the system to run the install wizard.
Contact your system administrator, if this error keeps happening.
3-1. Default recording behavior: Select the best recording method. When Always recording is selected,
every image will be recorded. When Motion recording is selected, only motion detected images will be
recorded, and approximately 25~60% storage can be saved according to the levels of motion detection
sensitivities you have set.
4-1. Time synchronization: There are options to choose from.
Time synchronization can be applied to all connected cameras.
You can also make this NVR as time server so that the time synchronization can be applied to all
the connected devices.
You can have the time on the system to be synchronized with the NTP time server.
5. Basic Settings: You can change or use the default account.
Select the “Use default password” option, if you wish to keep the default password.
I
nput a new password and confirm the newly
created password.
f you want to change the password, uncheck the option, i
Click “Next” to go to the next step Time.
Click “Next” to go to the next step Basic settings.
Click “Next” to go to the next step Network.
Note:
The system will restart when the server name is changed.
11
hard drives
Please seek for professional help, if you are not sure how to select the RAID level.
RAID Level
RAID
Description
Min.
HDD
HDD used
for Storage
Non-RAID
No protection,
but maximum capacity.
2
RAID 1
2
Half of HDDs
RAID 5
3
RAID 6
4
Best protection. Your
data will be mirrored.
Use 1 disk to store the
parity function data to
provide fault tolerance.
Use 2 disk to store the
parity function data to
provide fault tolerance.
All of HDDs
HDD number
minus 1
HDD number
minus 2