Surveon Linux Series Quick Installation Manual - page 3
/4
3/3
After the wizard installation is done, you will see the Live View page from the VMS.
Please refer to its user manual for the VMS Operation.
VMS
6
6. Network:
Different network settings can be applied to 2 LANs if there are 2 LANs on the system.
It is recommended to select “Auto detect”, since the system will detect if there is any
DHCP server available. If yes, it will assign an IP address.
You also can select “Use fixed IP” to input the IP address of this NVR and make this NVR as a DHCP
server. After selecting, input the relevant information and check “Enable DHCP service on this
NVR” to confirm the setting.
Warning: Make sure that only 1 DHCP server is activated in your system,
otherwise it may cause network errors.
Click “Next” to go to the next step Summary.
7. Summary:
This page shows the setting results you have set so far. Check if the results are what you
wished for. If not, click on the items you wish to modify to go back and set up again.
If you wish to set up the local display, you can click this item and go to the Local display page.
Local display: Select the best method for your scenario to have a balanced resource usage for the
quality of recording and local display.
8. Progressing: After clicking “Next” on the summary page, the wizard will start to initialize your system.
This act will take a few minutes to complete. Once it is done, the system will reboot automatically.
go to the next step Progressing.
After clicking “Next”, the wizard will start to initialize your system and
9. All complete: All the necessary settings are done. Click “Finish” to close this window and the system will
be directed to the VMS.
You can modify and configure more settings later in the setup page.
9-1. Camera detection: The system will detect the cameras in the same LAN.
Click the detection result to go to the next step Add camera.
Click “Finish” to close this window.You can add cameras later in the setup page.
10. Add camera: The detected cameras will be shown here. Select the cameras you wish to add and
click “Add selected” to add the selected cameras.
Click “Rescan” to detect the cameras again.
Click “Finish” to close this window.You can also add cameras later in the setup page.
Note:
The system will restart when the setting is changed.