Sussman W500 Installation And Operating Instruction - page 6
Models W500 & W510
TO PREVENT SHOCK HAZARD, BE CERTAIN THAT ELECTRICITY IS
TURNED OFF AT THE MAIN PANEL BEFORE ANY WIRING IS DONE.
BOX CONTENTS:
• Towel Warmer
• (1) Small allen key
• (6) Screws
• (1) Large allen key
• (1) Compression flange
• Instruction & Operation Manual
• (1) Decorative cover
• Waranty
• (1) Lower wiring flange
1. Place the compression flange on the upper support
bracket.
2. Using the smaller allen key provided, loosen the wiring
box set screw. DO NOT remove the wiring box.
3. Rotate the wiring box as shown. Tighten the set screw
firmly to prevent the wiring box from rotating.
4. Place the towel warmer in the desired location and
mark the location of the upper compression flange and
wiring box. Use a level to insure proper alignment.
*Note the WarmaTowel swing range.
5. Remove the compression flange from the upper support
bracket. Mount the compression flange to the wall with
the screws provided.
6. Slide the decorative cover onto the upper support
bracket as shown.
7. Insert the upper support bracket fully into the
compression flange.
8. Tighten the nut on the compression flange. Slide the
decorative cover over the compression flange.
9. Mount the lower wiring box per instructions on page 4.
NOTE: The compression flange nut can be rotated
to adjust flange center.
If a single gang electric box has
been roughed-in, then see page
2 for installation instructions.
5
Level
Upper Support Bracket
Compression Flange
Wiring Box
Compression
Flange Nut
Compression
Flange
Decorative
Cover
Upper
Support
Bracket
WARNING
!
WARNING
!
WarmaTowel
Installation and Operating Instruction
®