SVAT PI300-SD User Manual - Svat Electronics
7
PI300-SD User’s Manual
SVAT ELECTRONICS
now you can see
SETTING THE LCD ALARM CLOCK
NOTE: The time displayed on the LCD Alarm Clock must set independently from the time
setting on the covert DVR
PI300 is a covert DVR hidden inside of a fully functional LCD alarm clock. Follow these basic steps to setup
the external alarm clock portion of your covert DVR:
To set the time:
1. Adjust the Time Switch (10) to the mid position, this will enable time set.
2. Press the hour button (12) to increase the time, in hours, by one.
3. Press the minute button (14) to increase the time, in minutes, by one.
4. When you have finished setting the time, adjust the Time Switch to the down position to prevent any adjustments.
To set the alarm:
1. Adjust the Time Switch to the up position, this will enable alarm set.
2. Press the hour button to increase the alarm time, in hours, by one
3. Press the minute button to increase the alarm time, in minutes, by one.
4. When you have finished setting the alarm time, adjust the Time Switch to the down position to prevent any accidental adjustments.
To enable the alarm:
1. Adjust the Alarm Switch (11) to the up position to enable alarm.
2. Adjust the Alarm Switch to the down position to disable alarm.
To turn off the alarm / use the snooze button:
When the alarm is set and enabled, an audible buzzer will sound at the set time.
1. To turn off activated alarm, move the Alarm Switch down to disable alarm
2. While alarm is activated, press the snooze button (13) to disable the alarm for 9 minutes. After 9 minutes, the alarm will sound again and you will again be prompted to either press
the snooze button or turn off the alarm.