Sven NITRO Operation Manual - Eng
ENG
5
Operation Manual
NITRO
Fig. 6
7. CONNECTION AND INSTALLATION
• Install the device on an even surface (for example, on a table) on its suction caps. If necessary
fasten it with the two fixation stands (Fig. 5).
• Connect the pedal unit to the device (Fig. 5) via the pedal unit cable to RJ-11 jack r, then
connect USB cable t of the device to the available USB port of the computer.
• Insert the Software CD disk into the disk drive of your PC and launch setup.exe to install drivers
on your PC. Go to the game controller settings in the control panel and Game Controllers window
should appear on the Desktop of your PC (Fig. 6).
Wheel Test
• Axes Test. Pass to the “Test Page” bookmark (see Fig. 7), rotate the wheel from left to right and
make sure that the X-axis (“+” cross-cursor) in the “Axes Information” window moves from left to right
correctly. If the cross cursor is not at the center of the window, please enter “Calibration Page” to
calibrate it.
• Button Test. Press the wheel buttons to see if button 1 to 12 in the “Test Page” turns red for each
button action (see Fig. 7).
• D-PAD Test. Press each direction of the D-PAD (UP, DOWN, RIGHT, LEFT and 45 degree for each
direction) to see if the cursor in “Povinfo” is moving correctly (see Fig. 7).