Sven NITRO Operation Manual - Eng
ENG
8
Game Racing Wheel
Button Programming (no memory)
• Program buttons 1, 2, 3, 4, 5, 6, 7 and 8, which by default assigned functions to gear stick i, left
wing and right wing d, gas pedal v, brake pedal u, buttons 11 and 12. Which, you define by
testing. If for some reason they need to be reprogrammed, to set other functions, do the following
guidelines:
• Program Setup (no programming function under NEGCON Mode). Enter “Test Page” (see Fig. 8),
press button 9 and button 10 n at the same time. Hold for 3 seconds until program LED turns green.
Press the programmable button. Program LED starts blinking. Press program source button. Program
LED turns off. Program is set.
• Clear Single Program. Press button 9 and button 10 at the same time. Hold for 3 seconds and
program LED turns green. Press programmable button. Program LED starts blinking. Press progra-
mmable button again. Program LED turns off. Single program is cleared.
• Clear All Programs. Press button 9 and button 10 at the same time. Hold for 3 second until
program LED turns green. Release the buttons. Press button 10 and hold for 4 seconds. Program
LED turns off. All programmed buttons are cleared. Default is restored.
Wheel Sensitivity Adjustment (3 levels):
• Wheel sensitivity can be adjusted by a toggle switch Sensitivity q. There are 3 optional sen-
sitivities: «LO», «MID», «HI».
• By using switch Sensitivity q can be set three levels of sensitivity steering in position “LO” for the
full twist “wheels” to turn the steering wheel to lock, i.e., all 135 degrees. In the position “MID”
enough to turn the rudder to 2/3 speed, and in position “HI” maximum position is reached at the
third steering.
Mode Button Function:
• Press Select + Start (9+10) within 3 seconds to switch the mode, the Mode indicator turns green,
and then press the button of the left direction on the digital unit. The analog mode is activated after
that. In the digital mode the static maximum activation/deactivation of corresponding axes take place
during depressing the pedal, i.e. there is only “ON/OFF” position there. In the analog mode a signal is
transmitted depending on the pressure force of pedals, i.e. smoothly. The mode of buttons will not
function, when a certain mode has been already set on the console. LED indication of a mode
testifies about any current active mode.
Operation without pedal unit:
• Game racing wheel is equipped with paddle shifters d, that substitute acceleration and brake
pedals: the left paddle shifter functions as a brake pedal, while the right paddle shifter functions as
an acceleration pedal.
Note. Game racing wheel is equipped with braking indication g and accelerating indication
j see. Fig. 1. With a smooth pressing the acceleration pedal indicator lights up green,
picking up speed indicator will light orange, then red. Depending on the smoothness of
dropping speed indicator lights green, orange and red colors.