T&D TR-81 User Manual - page 2

Notices about this User’s Manual

- 

Please read this manual carefully before using the product.

- 

This manual can not be reprinted, so please keep it in a safe place.

- 

We cannot guarantee nor or we responsible for safety if this product is used in any man-

ner other than was intended.

- 

Please follow the safety precautions carefully.

- 

Contents of this manual may be altered according to improvements made to the product 

without notification.

- 

On screen messages in this manual may vary slightly from the actual messages.

- 

Figures in this manual may be slightly simplified and may differ from the actual product.

- 

Please notify us of any unclarities, mistakes or errors in this manual.

- 

Reproduction or use of any part or all of this manual is strictly forbidden.

- 

Please carefully read the guarantee and provisions for free repair.

- 

Microsoft and Windows are registered trademarks of Microsoft Corporation in the United 

States and/or other countries.

- 

Windows Vista is either a registered trademark or trademark of Microsoft Corporation in 

the United States and/or other countries.

- 

Company names and product names are trademarks or registered trademarks of each 

company.

FCC Compliance Statement for American Users

This device complies with Part 15 of the FCC Rules.

Operation is subject to following two conditions: (1) this device may not cause harmful interference. and 

(2) this device must accept any interference received, including interference that may cause undesired 

operation.

NOTE:

This equipment has been tested and found to comply with the limits for a Class A Digital Device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Warning

This equipment has been verified to comply with the limits for a Class A personal digital device, 

pursuant to Subpart B of Part 15 of FCC Rules. Only peripherals (computer input/output devices, 

terminals, printers, etc.) certified or verified to comply with the Class A or B limits may be attached to 

this equipment. Operation with non-certified or non-verified personal computer and/or peripherals is 

likely to result in interference to radio and TV reception. The connection of a non-shielded equipment 

interface cable to this equipment will invalidate the FCC Certification of this device and may cause 

interference levels which exceed the limits established by the FCC for this equipment.

You are cautioned that changes or modifications not expressly approved by party responsible for 

compliance 

could void your authority to operate the equipment.