T-Fal SENSOR 2 Operating Instructions Manual - T-Fal
If you can’t close the cover:
If the Pressure Cooker has heated
without any liquid inside:
If the pressure indicator pin has not
risen and no steam is released from
the valve during cooking:
If the pressure indicator pin has risen
and no steam is released from the
valve during cooking:
If steam escapes from under the
cover, check that:
If one of the safety systems (safety
valve or gasket) is activated:
If you cannot open the cover:
If the food is under-cooked or burnt,
check:
If food has burnt in the Pressure
Cooker:
If one of the safety systems comes
into operation:
■
Check the position of the lock undermeath the cover’s
handle. If it is not in the forward position, hold the cover and
push it forward.
■
Have your Pressure Cooker checked by an Authorized
T-Fal After-Sales Service Center.
■
This is normal for the first few minutes.
■
If this persists check that:
The heat setting is high enough. If not turn it up.
There is enough liquid in the pot (see page 5).
The pressure regulator valve is set to 1 or 2.
The Pressure Cooker is properly closed.
The gasket and the rim of the pot are not damaged.
■
Put your Pressure Cooker under cold water to decompress.
■
Clean the pressure regulator valve and the steam outlet.
■
The cover is properly closed.
■
The gasket is properly in place.
■
The gasket is in good condition. If not, replace it.
■
The rim of the pot is in good condition.
■
The cover, safety valve, pressure regulator valve and
gasket are clean.
■
Turn off the heat.
■
Allow the Pressure Cooker to cool down.
■
Check the pressure regulator valve and the steam outlet.
■
Check that the pressure indicator pin is in low position.
■
■
If not, cool the Pressure Cooker under cold running water
to release the pressure.
■
The cooking time.
■
The heat setting used.
■
The positioning of the pressure regulator valve.
■
The quantity of liquid used.
■
Allow the pot to soak in warm soapy water for a while
before washing.
■
Never use bleach or chlorine products.
■
Turn the heat off.
■
Let the Pressure Cooker cool down.
■
Open.
■
Check and clean the pressure regulator valve, steam outlet,
safety valve and gasket.
■
If the third safety device comes into operation, have your
Pressure Cooker checked by an Authorized T-Fal After-Sales
Service Center.
T-Fal
answers your questions
14
Sensor II USA 4131340 12/03/02 10:15 Page 14