T-Fal SENSOR 2 Operating Instructions Manual - Before Using
6
7
Before using
for the first time
■
Fill with water to 2/3 of the pot height.
■
Close the Pressure Cooker.
■
Set the pressure regulator valve to
2
.
■
Place the Pressure Cooker on the stovetop and set to maximum heat.
■
When the pressure indicator pin rises, and steam begins to escape
from the valve, reduce the heat and wait for 15 minutes.
■
After 15 minutes turn off the heat.
■
Release steam by turning the pressure regulator valve to
or leaving the valve on 2 and putting your Pressure Cooker under
cold running water.
■
When steam no longer comes from the steam outlet, and the
pressure indicator has dropped, open the Pressure Cooker.
■
Rinse the Pressure Cooker with cold water and dry.
■
For models with a non-stick coating, wipe the inside of the pot with
a little vegetable oil.
■
Note: The appearance of stains on the inside bottom of the pot does
not affect the quality of the metal. These are marks left by hard water.
Use diluted vinegar and a scouring pad to remove them.
2/3
Sensor II USA 4131340 12/03/02 10:15 Page 7