T.MIX DPM-1122 Owner's manual - page 11
11
39. COMP./BYPASSSwitch&LED
Push this switch, the LED will light up and you will activate the MAIN MIX COMPRESSOR. You can also
use the bypass switch to make a comparison between processed and unprocessed signal.
40. AUXSENDSConnectors
These 1/4” phone jacks are used to send out the signal from the
AUX bus to external devices such as effect units and/or stage
monitors.
41. MAIN MIX OUT
These jacks are used to output the signal of the MAIN MIX bus.
The final output level from these jacks is adjusted by the MAIN
MIX fader.
42. MONO OUTPUT Jack
Use this MONO jack to connect the input of an external amplifier
or active monitor speaker.
43. PHONESJack
This jack will be used to send the signal to a headphone or to a
pair of powered studio monitors.
44. FOOTSWITCHJack
This 1/4” jack can be used to connect an external foot switch to turn on/off
the onboard effect module.
(TIP terminal controls FX1, RING terminal controls FX2, sleeve terminal
connects common terminal.)
45. POWER AMP Switch
This switch is used to control the amplifier input signal.
46. POWER AMP. MODE Switch
This switch provides three modes: MAIN L/MAIN R;
AUX1/AUX2; BRIDGE. Select any one of these modes
to specify the signals to be routed to the corresponding
jacks according to the speaker connection at the speaker
jacks on the rear panel. For details please refer to later
content.
47. SignalLED
This LED will light up when the signal at the output is at least 100mV.
48. CLIPLED
This LED will flash when distortion reaches a level of 0.5%, turn the respective signal level control down
so that the LED only flashes occasionally.
49. Protection LED
It will light up when the unit is in protection mode due to overheating, short circuit, low impedance load or
other causes.