T.MIX DPM-1122 Owner's manual - page 4
4
Introduction
Thank you for your purchasing of THE T.MIX DPM 1122 16-channel Power mixer with 24-bit digital multi-effect
built-in. Your THE T.MIX DPM 1122 is a remarkable compact powered mixer that doesn’t find many equals in
the market today. With 12 microphone and 2 stereo line-level inputs for serious live performances, your THE
T.MIX DPM 1122 also includes a 24-bit digital multi-effect with 10 factory presets and 10 variations for every
preset, for a total of 100 different digital effects. There is a three bands EQ on mono input channels, four bands
EQ on stereo input channels. Use it for small gigs, church applications or conference.
Enjoy your THE T.MIX DPM 1122 and make sure to read this manual carefully before operation!
Features
12 MIC inputs, 2 stereo inputs, 2 AUX stereo inputs, 1 RCA 2-track input and 1
X
Ø
3.5 AUX stereo
input.
MONO channels:
X
Low-distortion MIC preamp with high dynamic range.
Balanced XLR and TRS inputs.
Lowcutfilters75Hz18dB/octoneachchannel.
3-band swept mid EQ on each channel.
+48VphantompowerwithoneswitcheveryfourMICinputs.
STEREO Channel:
X
Balanced TRS inputs.
+/-20dBsignallevelcontrols.
4-band EQ on each channel.
MUTE,PFLswitches,PEAKLEDandahigh-quality60mmfaderoneachchannel.
X
4AUXsends:AUX1/2areconfiguredasswitchablePRE/POST,AUX3/AUX4forinternalDSP&
X
discrete output.
2 built-in DSPs sending signal to AUX sends or main mix bus.
X
7-bandgraphicEQ.
X
CompressorwithvariablethresholdandratioonMAINMIXbus.
X
12segmentsignallevelmeters,usePFL(AFL)/MAINMIXswitchtochangePHONES/CTRL-ROOM
X
output signal.
Built-inhigh-qualityDclassamplifierwithsignal,CLIP,andprotectionLEDs.
X
Quick Start
This is the fastest way to get something out from your THE T.MIX DPM 1122, if you have a keyboard and a
microphone.
1. Plug the microphone into channel 1 MIC IN.
2. Turn down AUX and LEVEL controls on that input channel.
3. Put the EQ controls on centre position.
4. Connect 2 passive cabinets to the rear speaker output sockets.
5. Turn on your THE T.MIX DPM 1122.
6. Sing or speak into the microphone with normal volume and adjust the channel fader of half.
7. If you like, you can adjust the EQ at this stage.
8. The CLIP LED on the L/R master LED meter should flash only occasionally, otherwise you will hear distor-
tion. If this LED is not active and you still hear distortion, please turn down a little the input TRIM control.
10. Connect a stereo keyboard to channel 13/14 and repeat the above sequence. If the CLIP LED is not ac-
tive but you hear distortion, please reduce the output level of the source instrument
Here you are. It is your first gig with your THE T.MIX DPM 1122.