T.MIX pm184x Owner's Manual - page 4
5
6
(5)HIGH FREQUENCY EQUALIZATION CONTROL
Provides
15dB of fixed frequency equalization that shelves at 12KHz.
(6) MIDRANGE GAIN CONTROL
It has up to 15dB of cut and boost, with a centre detent for off.
(7) MIDRANGE CONTROL
It is semi-parametric with peaking response, Q fixed at 1 octave, sweepable from 100 Hz to 8 KHz.
(8).LO FREQUENCY EQUALIZATION CONTROL
Provides
15dB of fixed frequency equalizationthat shelves 80Hz.
9) AUX CHANNEL
It provide pfl reverb or be connected with other related equipments.
(10) AUX SIGNAL SWITCH
Adjusting the switch, you can know where the signals are from?
(11) DIGITAL EFFECTS PROCESSOR
It is integrated effects processor which offers 32 different standard effects like reverb, chorus, delay, pitch shifter and various
combination effects.
(12).PAN CONTROL
The pan control sends continuously variable amounts of the post fader signal to either the
Left & Right main busses. In the center position,equal amounts of signal are sent to the and right
busses. As the control is roated in either direction,more signal is sent to the buss indicated in the
direcction of the rotation while less signal issent to the other buss, if the control is turned all the way to one side, the signal is only.
(13) PRE-FADER LEVEL(PFL)
Pressing channel mode switch once disengages the stereo solo bus, and replaces it with a separate mono pfl bus. Pfl should always be
used for gain setting.
(14) BUS ON/OFF
This switch, when push, put the signal into bus and output from alt3-4
(15).CHANNEL FADER
You can adjust the volume of signalsources which connected to the relevant channel.
(16), (17),STEREO RECORDER &PHONO JACK
(16), these jacks can be connected with cassette cleek. When playing back recorded.
(16), these jack are can be connected with cassette cleek. When recording the MIXED output.
(18), (19), (22), (23) LINE IN
(18) line in for channel 7/8 (19) line in for channel 9/10.
(22) line in for channel 11/12 (23) line in for channel 13/14.
(20) CTRL ROOM CUT
(21) MAIN OUT
The output signal can be connected with the external main speaker and amplifier.
(24) HI MID
Adjusting the knob, you can have up to 15dB cut and boost at 3KHz mid and hi frequency.
(25) LO MID
Adjusting the knob, it have up to 15dB cut and boost at 500Hz mid and low frequency.
PM SERIES PROFESSIONAL MIXING CONSOLE
PM SERIES PROFESSIONAL MIXING CONSOLE