T Scale ATW series User Manual - Section 8 Parameters
ATW
digital weighing scales user’s guide
-10-
SECTION 8 PARAMETERS
The scale has 6 parameters that can be set by the user. These allow the user to set
the scale to:
Display the weight in other increments of weight to min the affects of vibration,
wind or other environmental conditions.
Control the back light on the display. It may be necessary to turn the backlight
off to maximum battery life.
Set auto zero range
Select another weighing unit than the standard.
To set parameters press the limit and unit keys at the same time.
The backlight is control. The standard is to have the backlight operate automatically,
turning off when the scale is not used. The backlight can be set to be "EL On" ,
"EL Au" (Automatic) or "EL Off". The maximum battery life is achieved with the
backlight turned off.
Press the TARE/ key to change the value then press the ZERO/ENTER key.
The displayed unit of weight is set. The scales are normally calibrated and display in
kilograms, however they will show the weight in kilograms, ounces or pounds and so
on selected by this function.
Press the TARE/ key to change the value then press the ZERO/ENTER key.