TA ACON 34 User Manual - Power Supply +12 V
Power supply +12 V
The converter is supplied by the 12 V connection of a freely programmable controller or by an
external power supply unit (12 V).
Regardless of the connection, the PCB is protected against short circuits for one minute.
A resettable fuse (0.5 A) is installed internally upstream of the supply input.
With no output load, the device typically draws a standby current of 6 mA.
1.
0-10 V to 0-20 mA converter
In addition to the 0-10 V signal, a current of 4-20 mA is also a standard interface.
This level converter generates current that is proportional to the input voltage.
The minimum current of 4 mA is not generated and must be achieved by programming the
0-10 V source accordingly.
Accuracy +/- 0.5 mA
12 V DC
Power supply
Earth
0-10 V signal
0-20 mA signal
Earth