TAG Heuer HL 670 User Manual - page 3
1. Functions
The Transmitter :
1.
IMPULSE
Input for timing Impulse (Start gate, photocell – working / closing contact). Respect the polarities.
2.
DATA
Male Sub-D 9: RS232 input for
DATA
transfer
3.
POWER
To switch on the receiver (press for 3 seconds on POWER). The green LED is on.
To switch off the receiver, hold down SET and press POWER.
4.
SET
To program the TEAM (A, B, C, D) and to switch off the receiver. Hold down SET during the changes.
5.
TEAM
To check the programmed TEAM.
To change the code, hold down SET and press TEAM.
6.
CHANNEL
To check the programmed CHANNEL.
To change the CHANNEL, hold down SET and press CHANNEL.
7.
TEST
For testing the Impulse transmission only. The reception level will be displayed for 0.2 seconds on the
receiver. You’ll also get an Impulse on the programmed output.
8. TEST BATT
To check the state of the battery. Press TEST BATT : The Battery level will be displayed with the 4 LED’s
for 2 seconds.
9.
LED
LED control panel which shows the programmed TEAM or CHANNEL. Also shows the transmitted Impulse.
10.
LED
Shows the transmission mode :
IMPULSE
or
DATA
11.
CHARGE Charging status Leds. The red led indicates that the Accu is charging. The charge is completed as soon as
the green LED in on.
1
2
3
8
7
4
5
6
9
11
10
10
10
10