TAG Heuer HL 670 User Manual - page 7
4. Software Update
With the Firmware (already used with the Chronoprinter 540 and the Minitimer HL440)
able you to change the transmission mode and Update your device.
For this application you need :
• The RS232 cable (HL605-10)
• A computer fitted with a D-Sub9 RS232 Output
• The software « Firmware.exe »
How to proceed
1. With the radio switched « OFF » connect the external power Connect the RS232
between your computer and the HL670
2. Run «Firmware.exe »
3. Select the correct COM Port
4. Browse and select the correct file (Rx/Tx)
5. Push START on the screen
6. Turn on the HL670 (hold down for 5 seconds « ON »
The HL670 will enter in a special setup mode
7. Until the file downloaded then, validate with « OK »
For each device, transmitter or receiver, two Software options are available :
o
TAG Heuer Software (
TH_Tx_Vxx
/
TH_Rx_Vxx
)
This software is especially dedicated for the standard CP540 protocol and the
Minitimer. The 9600 with flow control Baud rate ensure that the frames are
correctly transmitted.
o
Chronelec Software (or transparent mode) (
THbC_Tx_Vxx
/
THbC_Rx_Vxx
)
This mode is especially for devices which need a data transmission with different
frame length. The data transfer is made until the device receives a blank
message within 50ms with a maximum frame length of 127 characters.
The transmission for 43 octets (standard CP540 frame) takes 125ms with 9600 bps.
The timeline is composed
-
35ms for the RF transmission. This time does not depend on the baud rate just
on the number of octets.
-
45ms for sending the frame
-
45ms for receiving the frame on the receiver