Tait TM9100 Installation Manual - 3.4
TM9100 110W Mobile Radio Installation Guide
Installing the Radio
15
© Tait LimitedOctober 2012
2.
Run the supplied power cable (or one with a higher current rating)
between the radio’s mounting position and the vehicle battery (12V)
and cut it to length, allowing approximately 8 inches (20 cm) excess
at the radio end.
3.
Cut the negative (black) and the positive (red) wires where the in-line
fuse holders will be placed (as close to the power source as possible).
Notice
Do not install the fuses until the installation is ready to be
checked. For more information, refer to
“Checking the Installation” on
page 22
.
4.
Insert each end of the negative wire into each of the fuse
crimp-terminals and crimp them to force the metal contacts onto
the wires.
5.
Push the two crimp-terminals into the clear plastic fuse cover. Close
the cover while the next steps are completed.
6.
Repeat steps 4 and 5 for the positive wire.
7.
Connect the negative wire to the battery ground terminal.
8.
Connect the positive wire to the battery positive terminal.
Notice
Do not install the fuses until the installation is ready to be
checked. For more information, refer to
“Checking the Installation” on
page 22
.
3.4
Installing the Remote Control Head
1.
Choose a suitable location for the control head.
2.
Mount the control head according to the instructions supplied (IPN
402-00020-xx). Make sure that you follow the warnings and cautions
in these instructions.
The remote control head back (TMAA03-03) has already been fitted to
the control head and the dual RJ-45 torso interface (TMAC34-1T) has
already been fitted to the radio body.)
3.
Run the remote head cable (TMAA04-01) from the control head
location to the radio mounting location.