Tait TP9300 User Manual - Attaching The Battery

 Before using your radio  35

Attaching the battery

Warning 

Use only a Tait-supplied, IS and 

NI-approved battery with an IS and NI radio.

Notice 

Fit the bottom edge of the battery to the radio, 

then the top edge. Attempting to fit the top edge first 

may damage the contacts.

1

Rotate the power/volume control switch 

counterclockwise to turn off the radio.

If the battery has been attached while the radio 

is turned on, turn the radio off and then on again 

before use.

2

Holding the radio firmly, align the back of the 

battery with the back of the chassis.

3

Place the two lugs at the bottom edge of the 

battery into the two slots in the bottom of the front 

panel.

4

Lightly press the top of the battery towards the 

radio until the battery catch clicks.

5

Make sure that the battery is firmly in position.

Removing the battery

The battery is secured to the radio by a battery catch 

in the radio’s rear panel.

To remove the battery from the radio, so that the 

battery can be charged or replaced:

1

Rotate the power/volume control switch 

counterclockwise to turn off the radio.

If the battery has been removed while the radio 

is turned on, turn the radio off and then on again 

before use.

2

Slide the battery catch up.

3

From the sides, pull the battery away from the 

radio.