Tait TP9300 User Manual - Attaching The Antenna

36  Before using your radio

Attaching the antenna

Before using the radio, screw the antenna clockwise 

into the antenna connector. The antenna should be 

screwed sufficiently tight so that it doesn’t unscrew 

easily. This is important as it creates a seal.

Removing the antenna

Warning 

Do not change the antenna in a hazardous 

location. An explosion could cause serious injury or 

death.

Use a firm grip and turn the antenna counterclockwise 

half a turn. Use a lighter grip to fully unscrew the 

antenna, and carefully remove it.

Attaching a belt clip

To attach a belt clip to the radio:

1

Slide the belt clip into the two grooves at the top of 

the battery.

2

Press down on the belt clip until it snaps into place.

Removing a belt clip

The belt clip has been designed to prevent accidental 

removal, but you can take it off, if required.

To remove a belt clip from a battery:

1

Insert a flat screwdriver blade or similar flat object 

under the lip of the release lock (that is, between it 

and the metal slider).

2

Lift the release lock up (away from the metal slider) 

and hold it in position.

3

Slide the belt clip out.