Takex PR-11BE Instruction Manual - page 4
※Use outside dia. 1.50" (38mm) to 1.77" (45mm) pole.
①Insert 2pcs. of oval countersunk head screws (M4×20)
into the pole bracket with a few turns.
②Fix pole mounting plate to pole with the pole bracket.
③Fix sensor mounting plate or reflector mounting plate on
the pole mounting plate with 2pcs of M4×6 screws
attached to it.
①First, fix the pole mounting plate for the 1st unit.
②Let the 2nd unit pole bracket run under the 1st unit
pole mounting bracket and fix the 2nd pole mounting
plate up side down.
Pole bracket
Pole bracket
Pole mounting
plate
・Follow the same procedure as ③ to ⑤ of wall mount.
・Not applicable for the reflector.
5.91"
(150mm)
0.79"
(20mm)
POLE MOUNT
BACK TO BACK POLE MOUNT AND
RIGHT ANGLE POLE MOUNT
①Insert self tapping screws into the wall by about 0.79"
(20mm) and hang the reflector unit back plate on them
using the holes.
Set the center of the reflector unit and minddle point of
the sensor lenses at the same height, and you will find
it easier to adjust alignment.
The reflector unit should be installed uprightly and
vertically.
Make sure that the reflector's front side faces the
sensor.
②Tighten the screws until the reflector unit is fixed
firmly.
③Fix 3 reflectors to the reflector unit firmly.
※For indoor use, hood is not necessary.
Sensor mounting plate
SENSOR
●
Follow the same procedure as ③ to ⑤ of wall mount.
Detach cover, and
remove mounting plate
from sensor body.
REFLECTOR
pole mounting
plate
●
Follow the same procedure as wall mount.
reflector unit
Assembly
Wall
Center of reflector
When reflector
is detached
Insert reflectors
parallel to the
reflector holder
Holes
Self tapping screw
・Reflector