Tally Dascom DP-530 Operator's Manual - page 15
12
www.dascom.com
| +49 (0) 731 2075 0
Rear Paper Sensor Threshold (DP-530L models only)
Possible values 0-100%. Default value is 75%
When using paper with a Black on the back adjust this setting to ensure the paper stops at the Black Mark.
• If the printer is not detecting Black Marks reliably, set the Mark Sensitivity to a lower value.
• If the printer is detecting false Check Paper conditions, set the Mark Sensitivity to a higher value.
• If the printer is detecting Black Marks where none exist, set the Mark Sensitivity to a higher value.
Gap Paper Sensor Threshold (DP-530L models only)
Possible values 0-100%. Default value is 75%
When using labels without a Black Mark, adjust this setting to insure the label stops at the gap in between
labels.
• If the printer is not detecting gaps between labels reliably, set the Gap Sensitivity to a higher value.
• If the printer is detecting gaps where none exist, set the Gap Sensitivity to a lower value.
Backup Distance Before Printing
Used with Mark Seek. User defined. This is the distance the printer will pull in the paper before starting to print.
Max Mark Search Distance
Used with Mark Seek. User defined. This is the distance the printer will advance paper to seek the mark before
displaying a Paper Out condition.
Stop Distance after Mark
Use with Mark Seeking. User defined. This is the distance the printer will advance the paper after the mark is
detected.
Left Margin
Setting this value will tell the printer how far from the left edge of the paper to start the print job.
Contrast
Possible values 0
– 10. Default value is 5
The lower the value the lighter the print. The higher the value the darker the print.
Paper Energy Values
This is a locked value. These settings are supplied by the paper manufacturer. The default settings cover most
grades of paper. If you are using non-standard paper consult the paper manufacturer for recommended
settings.