Tally T6218 Maintenance Manual Supplement - Procedure 13A:
of
55
Removing and Replacing Components
P/N 1149-084775
Tally Printer Corp.
25
Procedure 13A:
Surge Capacitor Replacement
Step 1:
If the “surge capacitors" are being removed/replaced, remove two (2)
screws from each side of the clamp around the capacitors. Ensure
proper polarity of the capacitors during installation.
Figure 7. Surge Capacitor and Screw Location
Procedure 20: Power Supply Removal
Note: The procedures in the T6215 are applicable in the T6218. However, notice there are
two individual power supply assemblies inside the power supply cover. The power
supply assembly is replaced as a complete assembly only
(cover and both supplies)
due to voltage variation specifications.
Figure 8. Power Supply Assembly