Talon Tools FH2700 User Manual - page 2
This manual covers the operation and maintenance of Talon High Pressure Cleaner. Please read and
understand this manual before using your new High Pressure Cleaner. If assistance is required, please
contact Talon Tools Australia or any Talon Tools Authorised Servicing Dealer.
To emphasise special information the DANGER, WARNING and CAUTION icons are used, please
observe these carefully.
Congratulations on your purchase of a quality Talon product.
WARRANTY...................................................................................................................... 1
INTRODUCTION............................................................................................................... 2
GENERAL SAFETY RULES............................................................................................ 4-6
TECHNICAL SPECIFICATIONS...................................................................................... 7
GENERAL IDENTIFICATION........................................................................................... 8
ASSEMBLY INSTRUCTIONS........................................................................................... 9-13
STARTING THE ENGINE................................................................................................. 14
PRE-OPERATION............................................................................................................. 15-16
OPERATION..................................................................................................................... 17-21
SPRAY LANCE................................................................................................................. 21-23
CHEMICALS & CLEANING SOLVENTS......................................................................... 23
TROUBLE SHOOTING..................................................................................................... 24
INDEX
NEVER fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.
NEVER fill fuel tank completely. Fill tank to 13mm below bottom of filler neck to provide space for fuel
expansion. Wipe any fuel spillage from engine and equipment before starting engine.
NEVER run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon
monoxide, an odorless and deadly gas.
DO NOT let hoses come in contact with very hot engine muffler during or immediately after use of
your pressure washer.
Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
NEVER pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.
DO NOT use hot water, use cold water only.
NEVER turn water supply off while pressure washer engine is running or damage to pump will result.
DO NOT stop spraying water for more than one minute at a time. Pump operates in bypass mode
when spray gun trigger is not pressed. If pump is left in bypass mode for more than one minute
internal components of the pump can be damaged.
WARNING
CAUTION
2
When using the high pressure setting, DO NOT allow the high pressure spray to come in contact with
unprotected skin, eyes, or with any pets or animals. Serious injuries can occur.Your washer operates
at fluid pressures and velocities high enough to penetrate human and animal flesh, which could result
in amputation or other serious in juries. Leaks caused by loose fittings or worn or damaged hoses can
result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician
immediately!
DANGER
3
INTRODUCTION
AU
INDEX
AU