Talon Tools FH2700 User Manual - page 5
9
8
KNOW YOUR PETROL HIGH PRESSURE CLEANER
GENERAL IDENTIFICATION
AU
1
2
4
11
3
5
6
7
8
9
24
22
21
20
13
19
10
16
18
17
23
1.
High Pressure Gun
2.
High Pressure Hose
3. Air
Filter
4.
Throttle Lever
5.
Choke Lever
6. Fuel
Lever
7. Spray
Wand
8. Quick
Connect
Fitting
9. 8î
Wheels
10. Starter
Handle
11.
Oil Fill Cap
12. ON/OFF
Switch
13.
Chemical Injection Siphon/Filter
14. Fuel
Tank
15.
Fuel Filler Cap
16. Knob
Assembly
17.
5 Quick Connect Spray Nozzles
18.
Gun/Hose Storage Handle (Frame)
19.
High Pressure Outlet
20.
Water Inlet with Filter
21.
Thermal Relief Valve
22.
Hose Reel (FH2701)
23.
Detergent Tank (FH2701)
24.
Hose Through Slot (FH2701)
3-1. PREPARING PRESSURE WASHER FOR USE
To prepare your pressure washer for operation, you will need to perform these tasks:
• Attach accessory tray to handle, then attach handle to main unit.
• Add oil to engine crankcase.
• Add fuel to fuel tank.
• Connect high pressure hose to spray gun and pump.
• Connect water supply to pump.
• Attach nozzle extension to spray gun.
• Select/attach quick connect nozzle to nozzle extension.
3-2. ATTACH HANDLE AND ACCESSORY TRAY-FH2700
NOTE: All assembly operations given in this section will be described from the perspective of
assembling the pressure washer from the rear.
1. Place the handle assembly (A) onto the handle supports (B) connected to the main unit. Make sure
the holes in the handle align with the holes on the handle supports (Fig. 3-2A).
NOTE: It may be necessary to move the handle supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert the "J" bolt (C) through the hole on the right side of the handle (viewing from rear of unit) and
attach the plastic knob. Tighten the knob by hand (Fig. 3-2B).
3. Insert the carriage bolt (D) through the right side hole from the outside of the unit and attach a screw
from the inside of the unit (viewing unit from the rear). Tighten by hand or wrench. (Fig. 3-2C)
4.
Insert “U” bolt (E) through the hole adjacent to the accessory tray on the right side of the handle. Fit
nut to the inside and tighten with spanner (not provided) Fig 3-2D & Fig 3-2E.
Fig 3-2A
Fig 3-2B
A
B
Fig 3-2C
3. ASSEMBLY INSTRUCTIONS
12
C
D
E
C
D
Fig 3-2D
E
Fig 3-2E
ASSEMBLY INSTRUCTIONS
AU