Talovahti 66A User Manual - page 8
DYGSM Alarm System User Manual
————————————————————————————————————— 7 ———————————————————————————————————————
a).Works for Door Sensors Only;
b).After Enabling the Function, You will have to Press & Hold the [Out Arm] or [Home Arm] button for 3 seconds to arm the system if any Door/Window is open.
Otherwise, you can not Arm the system;
c).For sure, you can arm the system easily without enabling the function.
①
In setup state,→Select [Sensors] →Select [ENTER]
②
Select [Edit] → Select [ENTER]
③
Select [Auto Search Sensor] → Select [ENTER] →Triggering the Door Sensor you would like to Enable the function →Select [ENTER] when the Sensor’s
name displays on the Host screen;
④
Select [DOWN] → Select [Chime Zone] → Select [ENTER]
⑤
Select [UP] → Select [Yes] → Select 【SAVE】→ Enable the Auto Search Sensor successfully when you see the 【√】on The Host Screen
⑥
Select【BACK】to Exit.
7. Query the IMIE Code
①
In Setup state→ Select [Down] → Select [System About] → Select [ENTER]
②
Select[DOWN] → Select [IMEI] → Select [ENTER]
③
IMIE Code[15 digitals] will display on the Screen.
8. How To Use the CID Function?
The Standard ADMECO Contact ID Protocol was used in the Alarm System.
Firstly, You need to get a telephone number & User ID from your Service Provider .
www.deltasecurity.cn