Talvor 480A Owner's Manual - Gas Cylinders and
TALVOR
14
|
Gas cylinders and
regulator
The main valve on the LPG container should
be tightened by hand only, using caution
not to over tighten.
Handle your LPG bottles with care. When
connecting or disconnecting your gas
bottle, the connections are left-hand
threads. Always have your gas cylinder valve
closed when travelling or not in use.
Your gas regulator is factory preset and
you should never attempt to reset the gas
regulator yourself. Only allow licensed gas
fitters to make any adjustments to your
regulator or the RV’s gas system.
IMPORTANT:
Never refill your RV gas cylinder with any
gas other than LIQUID PROPANE GAS
(LPG) from an authorised distributor.
If you smell gas:
1.
Extinguish all open flames, pilot
lights and smoking materials.
2. Keep bystanders away.
3. Do not touch electrical switches
4. Shut off the gas supply at the
cylinder valve.
5. Open doors and other ventilating
openings.
6. Leave the area until the odour clears.
7. Have the gas system checked and
leakage source corrected by a
licensed gas fitter before using the
system again.
Gas cylinders generally have a life of ten
years after which time they have to be
restamped and certified by an authorised
company to ensure that your gas cylinders
are in safe working condition. Where
possible, in exposed salty conditions, they
should be covered to avoid the build up
of rust and you should always ensure that
the valve on the gas cylinder is turned off
before travelling and when storing your RV
for any length of time. Gas legislation may
vary from state to state, so it is the owner’s
responsibility to comply with relevant laws.
BBQ
Some Talvor models are equipped with a
BBQ. Please make sure it is securely stowed
by locking it in place before travel.
Please refer to the Manufacturer’s Manual
for operation.
Electric bed lift systems
The bed is moved up and down by an
electric motor and controlled by an electric
switch, the location of the switch may vary
dependant on model.
Refer to Manufacturer’s Manual for
operation.
IMPORTANT:
•
Do not operate the bed lift with
heavy load on it (max. 10 kg). Make
sure to take all bulky and heavy
goods off the bed before using the
bed lift.
•
Ensure bedding is not on moving
parts or other stationary items in the
vehicle to avoid jamming.
•
Make sure that the bed is raised
when you depart.
•
Do not put any goods on the bed
during transit.