Talvor 480A Owner's Manual - Brakes
Owners Manual |
17
Brakes
Talvor caravans are fitted with electric
brakes. These brakes may, from time to
time need adjusting. It is suggested that
all caravans be returned to the dealer
after approximately 2000km to check the
brake adjustment. If brake adjustment is
required during or prior to this time you
should contact the nearest dealer or your
original caravan manufacturer, to ensure
that this brake adjustment is carried out by
an authorised person.
This is a service
function not a warranty item
.
Please refer to the electric brake handbook
supplied with the caravan at the initial
time of delivery to learn more about the
operation and maintenance of your electric
brakes.
The warranty card on the brakes should be
filled out and returned to the brake supplier
so that your warranty is registered.
Breakaway system
If your unit is fitted with a breakaway
system, please refer to the supplied
operating instructions. A breakaway
system is standard equipment when GTM
exceeds 2000 kg. The breakaway system is
equipped with a 12V sealed rechargeable
5 amp battery and an in line charger.
Please refer to Manufacturer’s Manual for
further information on the operation and
maintenance.
Park brake cable
adjustment
In the laden condition it is imperative that
the park brake lever engages and secures
the brakes in the 5th or 6th notch of the
coupling, from the tow ball end. Failure to
adjust the cable tension in this manner will
through suspension movement, on both
independent suspension and beam axle
with leaf springs, cause the brake shoes to
be partially actuated and excessive heating
of the brake and drums to occur. Prolonged
use, if incorrectly adjusted, will initially
cause the back (secondary shoe) to overheat
causing disintegration of the brake lining
and will result in deterioration of brake
performance until eventual brake failure.
It is essential that the release of this hand
brake be carried out prior to travelling.
Please refer to the Manufacturer’s Manual
provided for more information.
Changing wheels
When changing wheels, only use the
jack mounting positions that are located
directly behind the axle on the main chassis
member or outrigger.
IMPORTANT:
•
Do not get under a vehicle that is
only supported by a jack - always use
vehicle support stands.
•
Use jack only with correct
engagement fittings.
•
Never change a wheel on soft,
uneven or sloping ground.
•
Do not remove wheel nuts until
wheel is off the ground.
•
Do not allow passengers in your
vehicle while it is on the jack.
•
Before use - read the label attached
to the jack.
• After use - ensure the flat tyre and
jack are properly secured.
Caravan Equipment