Tanberg E20 Administrator's Manual - page 13
D14330.05 ADMINISTRATOR GUIDE TANDBERG E20—MARCH 2009
13
What’s in this Guide?
Introduction
Getting Started
Using E20
The Settings
Administrator Settings
Getting started
4.
To be able to dial, you need to configure the SIP settings. In the Settings
> Administrator Settings > Advanced Settings > SIP, set SIP Mode to
Off before doing anything else. Set Default Transport to Auto (which is
the same as default), Proxy1 Discovery to Manual, You must also enter
the IP address of the Proxy (Proxy is your PBX/VCS or OCS) and you
must enter the URI of your E20. Set the SIP Mode back to On.
5.
If your SIP Server/PBX uses user authorization you need to supply a
user-id and password. This is done in Settings > Administrator Settings
> Advanced Settings > Advanced Configuration > SIP > Profile1 >
Authentication 1.
6.
You may want to use a TMS phonebook. If you have this and no entries
are displayed after configuring, you must make sure that your unit is
registered in TMS and a phonebook is assigned to your system.
Using the keypad to configure the E20
There are two ways of setting up the E20—by using the keypad or by
logging into the unit from remote. This page explains how to set up the
unit using the keypad, while how to set it up from remote is explained
on the next page.
Press the
H
ome
key to produce the
Home menu and navigate down to
Settings. Press the R
igHt
aRRow
key to produce the System settings
menu and navigate down to Adminstrator Settings. Press the R
igHt
aRRow
key.
Finally navigate down to Advanced Settings and press the R
igHt
aRRow
key again. Navigation like this will hereinafter be shown as Settings >
System settings > Administrator Settings > Advanced Settings.
1.
Navigate to SystemUnit > Name and press e
nteR
.
Select a name that is unique to avoid conflicts. We recommend
that you use your name or initials, eg. AliceWonderland. This name
will be seen as you by the others.
2.
In most cases DHCP will be used for assignment:
Go to the previous menu—the Administrator settings (use L
eft
aRRow
key) and navigate to IP Settings > IP Assignment, if the
cursor is not there already. Press
e
nteR
and set to DHCP.
Alternatively, set it to Static and enter the IP address, Subnet
Mask and Gateway IP address.
3.
For remote administration the below settings are recommended.
This should also make the system visible in TMS.
In the Settings > Administrator Settings > Advanced Settings >
Provisioning > ExternalManager set Address, Protocol, Path and
Mode, which will be TMS, if used.