Tanberg E20 Administrator's Manual - page 31
D14330.05 ADMINISTRATOR GUIDE TANDBERG E20—MARCH 2009
31
What’s in this Guide?
Introduction
Getting Started
Using E20
The Settings
Administrator Settings
Administrator Settings
TMS: If set to TMS the system will try to register with a TMS
server as described in the address and path settings. TMS is
short for TANDBERG Management System. Please contact your
TANDBERG representative for more information.
VCS: If set to VCS the system will try to register with a VCS as
described in described in the address and path settings. VCS
is short for Video Communication Server. Please contact your
TANDBERG representative for more information.
SIP
Profile 1
The SIP URI or number is used to address the system. This is the URI
that is registered and used by the SIP services to route inbound calls
to the system. A Uniform Resource Identifier (URI) is a compact string
of characters used to identify or name a resource.
Authentication
Login name: This is the user name part of the credentials used to
authenticate towards the SIP proxy.
Password: This is the password part of the credentials used to
authenticate towards the SIP proxy.
Default transport
Select the transport protocol to be used over the LAN.
UDP: The system will always use UDP as the default transport
method.
TCP: The system will always use TCP as the default transport
method.
TLS: The system will always use TLS as the default transport
method. For TLS connections a SIP CA-list can be uploaded using
the web interface. If no such CA-list is available on the system then
anonymous Diffie Hellman will be used.
Auto: The system will try to connect using transport protocols in
the following order: TLS, TCP, UDP.
Mailbox
Not used in this version.
MultiWay conference
Not used in this version.
Proxy 1
Address: The Proxy Address is the manually configured address
for the outbound proxy. It is possible to use a fully qualified domain
name, or an IP address. The default port is 5060 for TCP and UDP
but another can be provided.
Discovery: When Manual is selected, the manually configured
SIP Proxy address will be used. When Auto is selected, the SIP
Proxy address is obtained using Dynamic Host Configuration
Protocol (DHCP).
TLS verify
For TLS connections a CA-list can be uploaded from the web
interface.
On: Set to On to verify TLS connections. Only TLS connections to
servers, whom x.509 certificate is validated against the CA-list, will
be allowed.
Off: Set to Off to allow TLS connections without verifying them.
The TLS connections are allowed to be set up without verifying
the x.509 certificate received from the server against the local
CA-list. This should typically be selected if no SIP CA-list has been
uploaded.
Type
Enables SIP extensions and special behaviour for a vendor or provider.