Tanberg E20 Administrator's Manual - page 24
D14330.05 ADMINISTRATOR GUIDE TANDBERG E20—MARCH 2009
24
What’s in this Guide?
Introduction
Getting Started
Using E20
The Settings
Administrator Settings
The Settings
Description of the Settings available
On the following pages you will find a list of the settings available.
We recommend you visit the TANDBERG web site regularly for updated
versions of the manual. Go to: http://www.tandberg.com/docs.
To access the Settings, do as follows:
1.
Press the
key to produce the menu. Use the key to navigate
down to Settings and press either or use the key to navigate to
the right.
2.
The menu contains the following topics:
•
Call forward
•
Ring tone
•
Ring tone volume
•
Key tone
•
System settings
3.
Some of these menus have their own submenus. To navigate further
down in the menu hierarchy repeat
1.
above.
4.
To go one or more steps back in the hierarchy, use the key to
navigate to the left, the required number of times.
5.
To collapse all menus, press the
key.
6.
To put a change into effect, press as soon as the required setting
has been selected or changed.
The Settings
Call forward: This feature lets you forward all calls to a defined receiver.
Just key in the identity and activate the feature.
Ring tones allow you to select between the ring tones available. Use the
key to navigate up and down as usual. You will hear the different ring
tones as you move up and down.
Ring volume lets you set the volume of the incoming call signal. You will
hear the level as you adjust.
Key tones let you determine whether you should hear a sound every time
you press a key or not. Set to On to activate.
System settings include Date and time of day settings; Call settings;
Adminstrator settings and System information. The System settings are
treated separately below.
System Settings
Date and time:
This can be set to either manual or automatic.
If set to automatic the menu allows you to set the date, month, year and
the time of day in hours and minutes. Date format and time format settings
are also available.
Call settings:
Auto answer can be set to Off or On. When set to Off you must
respond to an incoming call to accept it, either by lifting the handset or by
pressing the key. When set to On, the call is automatically accepted.
Default bitrate in calls can be set to 1152, 768, 512, 384, 256 or 128
kbps.
Maximum upstream bitrate can be set to 1152, 768, 512, 384, 256 or
128 kbps.
Maximum downstream bitrate can be set to 1152, 768, 512, 384,
256 or 128 kbps.