TANDBERG FieldView User Manual - page 4
1
TANDBERG
FieldView External Charger User Manual
D14059.02 April 2007
Introduction
The external charger from TANDBERG is a battery charger
and conditioning station. The external charger provides a
conditioning cycle which ensures that the reported energy
from the smart battery (116314) will match its actual energy
thereby maximizing battery efficiency.
SAVE THIS INFORMATION FOR FUTURE
REFERENCE
NOTE:
PLEASE CHECK ALL PACKAGING FOR ENCLOSED
CONTENTS AS SHOWN BELOW.
ENCLOSED YOU SHOULD FIND:
1
External Charger,
1
AC/DC Adapter
3
Country specific line cords
1
Users Guide
Quick Start
Before powering your charger, be sure to read the safety
information on inside front cover.
Setup
Make sure that a battery is not installed in the charger,
Place the charger on a flat, dry, stable surface,
Plug the barrel jack from the power supply into the back of
the charger,
Plug the AC/DC power adapter into your AC outlet with the
appropriate line cord for the country where you operate
the charger,
The Mode LED will turn green when the charger has power.
Charger Operation
Inserting the Battery
Align the battery over the battery charger slot with the bottom of the pack lined up with the ledge on the plastic as
shown Figure 1.
If the battery is properly aligned four grooves on the battery pack will be aligned with four tabs on the charger.
Lower the battery onto the battery charger.
Once the battery pack is sitting flat on the charger, slide the battery pack towards the contacts until the battery pack
and external charger latch into place.
1.
2.
3.
4.
5.
1.
2.
3.
4.
Figure 1 Charger with battery installed