TANDBERG Videoconferencing System Short User Manual - page 11
TANDBERG Videoconferencing System
General use
11
ENGLISH
Disconnecting sites from a conference
To disconnect a site or end the conference, press D
ISCONNECT
.
• Select site and press O
K
or ‘Disconnect Site’.
To end the meeting press ‘Disconnect All’.
disconnect
Adding an extra site - dial in
To dial in to the MultiSite on ISDN-BRI:
• Site 2 must dial MultiSite Number 2.
• Site 3 must dial MultiSite Number 3.
To dial in to the MultiSite on ISDN-PRI:
• Dial the main number of the system (‘My ISDN Number’). All sites can dial the same number.
To dial in to the MultiSite on IP:
• Dial the IP Number or the IP Address of the system (‘My IP Number’/‘My IP Address’).
When the MultiSite receives an incoming call, the following menu is displayed:
• Pressing C
ONNECT
is equivalent to pressing ‘Accept’.
• Pressing D
ISCONNECT
is equivalent to pressing ‘Reject’.
• Pressing ‘Do Not Disturb’ will disable the MultiSite from answering more incoming calls during the current
conference. The calling party will receive a busy signal.
T
O
FIND
THE
DIAL
-
IN
NUMBERS
FOR
THE
M
ULTI
S
ITE
,
PRESS
‘M
ENU
’
AND
‘S
YSTEM
I
NFO
’
TIP