TANDBERG Videoconferencing System Short User Manual - page 15
TANDBERG Videoconferencing System
Installation
15
ENGLISH
ISDN configuration
For each installation of the system it is necessary to configure the unit. All configuration parameters are available
via the menu system.
• Press M
ENU
on the remote control. Select the menu ‘Terminal Settings’, then ‘Network’.
Set ‘Current Network’ to the network you want to use.
Specify the settings for the selected network in one of the menus.
Please refer to the User Manual for configuration of ISDN-PRI, Leased E1/T1 and External networks.
System configuration
• Switch the system on. Product logo and a power up menu will be displayed.
connect
menu
• Enabled but unused ISDN lines (lines not active) should be disabled:
P
RESS
M
ENU
ON
THE
REMOTE
CONTROL
. S
ELECT
THE
MENU
‘T
ERMINAL
S
ETTINGS
’, ‘N
ETWORK
’, ‘ISDN-BRI
SETTINGS
’. S
ELECT
THE
RELEVANT
‘L
INE
S
ETUP
’
MENU
AND
SET
‘E
NABLED
: O
FF
’.
• Enter System Name to identify the system during an MCU conference. Select ‘Utilities’, ‘System Name’and
enter the name using the number keys (as on a mobile phone).
• Select the language you want to use in ‘Terminal Settings’, ‘Language’.
• If you are using two monitors, set ‘Utilities’, ‘Dual monitor: On’.
• To activate MultiSite and/or Presenter, insert an option key (see paperwork accompanying your system), see
‘Terminal Settings’, ‘Software Options’.
• Press C
ONNECT
on the remote control. A dial tone should be heard if the network is active.
• Using the monitor remote control, adjust the volume on the monitor to a level of your choice. This
volume will be the default volume for all calls.