Tannoy V8 User Manual - page 11
The V8Y is a discreet yoke style bracket, available in both black and white, and is used to mount the
Tannoy V8 in both portrait and landscape orientations. The Tannoy V8 loudspeaker is fixed to the
bracket using the M10 bolts and washers supplied in the accessory pack
Only the screws, fasteners, shakeproof and plain washers specified on figure 3. should be
used to assemble the VMY bracket.
The arms of the V8Y have long slots, through which M10 bolts are fitted, and screwed into the
integral M10 inserts in the top and bottom of the Tannoy V8 cabinet.
These slots allow the installer to easily and precisely adjust the distance between the loudspeaker
and the mounting surface for optimal discreet installation of the Tannoy V8.
Use the 20mm hole to pass the loudspeaker cable through before fixing the bracket to the wall.
Use the table of parts along with the assembly drawing to assemble the V8Y.
Assembly View
Description
Quantity
1 Yoke
Bracket
1
2 Washer
M10
Plain
2
3 Washer
M10
Spring
2
4
M10 x 20 Button Head Screw
1
5
M10 x 30 Button Head Screw
1
6 Rubber
Friction
Washer
2
12.3 SECUR ET- VCB2 & VCB4
VCB2 :-
The VCB2 cluster bar is available in both black and white finishes and provides a platform onto which
2 x Tannoy V8 loudspeakers can be mounted using the V8Y yoke bracket (not supplied in the VCB2
kit). A number of different loudspeaker arrangements can be made depending on the application and
the coverage pattern required (see figures 1 & 2).
Using the VCS ceiling saddle the resulting cluster can be attached to the ceiling, or by using the
VPC pole clamp the cluster can be attached to trussing and a wide variety of structures within the
installation venue.
VCB4 :-
The VCB4 cluster bar (available in both black and white) provides the platform onto which 3—4 x
Tannoy V8 loudspeakers can be mounted using the V8Y yoke bracket (not supplied in the VCB4 kit).
A number of different loudspeaker arrangements can be made depending on the application and the
coverage pattern required (see figures 3—6).
N.B. When using the VCB4 cluster bar system, one of the cluster bars is mounted above the other to
produce a cross formation. To ensure an equal mounting height, the 2 x Tannoy V8 loudspeakers
being flown from the lower cluster bar should be attached to the upper surface of this bar. While the 2
x Tannoy V8 loudspeakers being flown from the upper bar should be attached to the underside of this
cluster bar.
Using the VCS ceiling saddle the resulting cluster can be attached to the ceiling. Or by using the
VPC pole clamp the cluster can be attached to trussing and a wide variety of structures within the
installation venue.
Fig 1.
Fig 3.
Fig 5.
Fig 2.
Fig 4.
Fig 6.
Enfocus Software - Customer Support
12.2 SECUR ET – V8Y Yoke Bracket